Please discontinue use of the charger and call the factory at 1-80. Honeywell T4 Pro Troubleshooting can be done by following a few simple steps. Please call the factory at 1-80 for further assistance.ĥ RED BLINKING LEDS……….OVERVOLTAGE PROTECTION This indication occurs if the charger circuitry has detected that the output circuitry is possibly defective. The charger may be reset by disconnecting and reconnecting the AC power supply cord. This could indicate a possible charger problem and the charge cycle has been terminated. Please call the factory at 1-80 for further assistance.Ĥ RED BLINKING LEDS……….INTERNAL OVERTEMP SHUTDOWN This indication occurs if the charger circuitry has detected operating temperatures inside the charger enclosure that are above factory specified levels. This indicates a possible battery problem and the charge cycle has been terminated at this point. Please call the factory at 1-80 for further assistance.ģ RED BLINKING LEDS……….OVERALL TIMER SHUTDOWN This indication occurs if the charger has not completed the charge cycle within the allowable factory set time period. Make sure the power switch for the heating/cooling system is on. Ensure all panel doors on the indoor unit are closed. The charger may be reset by disconnecting and reconnecting the AC power supply cord. Check the batteries and replace them if needed. This can include problems with the thermostat, ductwork, compressor, or other components. This indicates a possible battery problem and the charge cycle has been terminated at this point. Ameristar HVAC troubleshooting refers to the process of identifying and resolving issues with Ameristar heating, ventilation, and air conditioning systems. Please call the factory at 1-80 for further assistance.Ģ RED BLINKING LEDS……….FORMING STAGE TIMEOUT SHUTDOWN This indication occurs if the battery voltage has not risen above 1.75 volts per cell within the first 3 hours of charging. Also check for corrosion free secure connections to the battery. With the AC power supply cord unplugged, check the connection to the batteries for proper polarity (black wire to negative or -). The charger circuitry will not allow charge current to flow under this condition. RED BLINKING LED………….NO BATTERY DETECTED This indication occurs whenever the charger circuitry cannot detect a battery. High Pressure Sensor, Low Pressure Sensor, 2 Temperature Sensors, Batteries, Access Port Fittings, Carry Case. Listed below are the possible fault conditions and what they mean: (These fault codes are also present on all Eagle Series chargers) SMART Pro/R Low Side Pressure Transducer (300 PSIG) SMART Pro/R Temeprature Clamp. Q: Do your chargers have any fault code indications that may appear if there is a problem with my charger or my batteries?Ī: Yes, beginning in 2007, all Pro, SE, and XL Series chargers have been equipped with the capability of displaying fault codes. Frequently Asked Questions & Trouble Shooting
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |